GE Washer CAnCELEd Error Code
CAnCELEd on a 2017 and newer GE electronic control washer means the cycle ended early, followed by a 4-minute lockout.
Model Reference
GE GFW350SSYWW Repair
Odor, a locked-looking door and a no-fill message come up most often on a white 4.6 cu ft front-load washer, and most start at the door boot or the faucets.
Model number
GFW350SSYWW
About this model
Model overview
Why this washer smells
The GFW350SSYWW is a white (WW) GE front-load washer with a 4.6 cu ft drum. Front-loaders keep water in the soft rubber seal around the door, which is why the first complaint is often a sour smell rather than a breakdown. Wipe the gasket, fold it back to look for trapped lint, and leave the door slightly open after each load. In foggy neighborhoods a laundry closet may stay damp for days, which makes the habit worth keeping. The full routine is in front-load washer odor and door gasket care.
No water arriving
H2O SUPPLY, also shown as IE, means GE sees no water entering, either from a pressure sensor issue or from closed supply valves, and the washer locks out for four minutes. Open both valves fully, check the hoses behind the washer for kinks, and then try a new cycle. If the supply is fine and the message returns, schedule a visit. Details: GE Washer H2O SUPPLY / IE code.
Water left in the drum
When the cycle ends but the clothes sit in water, look for a kinked drain hose behind the cabinet and make sure the hose end is not pushed too deep. Keep the door closed, because opening it may release the water on the floor. Our post a GE washer that leaves water in the drum lays out the order of checks, and GE Washer FE code applies if the water level is critical.
Reading the label
GFW is front-load, 350 is a feature level, and the last letters, WW, mark the white finish. It is a current model. The drum size matches several other washers on our list, so confirm by model letters rather than by size alone; finding your GE model number shows where the label is.
Prepare for the technician
- Pull the washer out only if you can do it safely, or leave it and tell us how tight the space is.
- Keep the door closed and the load inside if there is water in the drum.
- Photograph the label and any message.
After the diagnosis you will see a written estimate, and the repair waits for your approval. Related: GE Washer Repair and GE Washers.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
FAQ
Frequently asked questions
Usually not. It is often residue in the door seal. Clean and dry it, and call us if odor comes with leaking or a failure to drain.
GE describes a four-minute lockout after H2O SUPPLY or IE.
Measure the washer you have, since dimensions can vary; read the full model number from the label when you book.
Look at the door frame and around the opening; if it is not visible, check the back or the lid area and photograph what you find.
Diagnostics
Error codes for this appliance
Fix it right
Repair service
Washer
Top-load, front-load and UltraFast combo GE washers: we find the fault at your place and quote it in writing.
Models
Other models
Book a repair
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Phone
(415) 729-2045
Hours
Mon–Sat: 8:00 AM – 7:00 PM
Service area
San Francisco Bay Area, California